Content was blocked because it was not signed by a valid security certificate September 1, 2010 // 0 Comments If you are getting the following message when accessing a website, “Content was blocked because it was not signed by a [...]
Microsoft Security Bulletin Minor Revision August 31, 2010 // 0 Comments ****************************** ************************************** Title: Microsoft Security Bulletin Minor Revision [...]
How to renew an IP address? March 18, 2010 // 0 Comments For those that are newbies in the Windows environment, here is how to renew an IP address in Windows. 1. Open the Command [...]
Outlook 2007 Certificate Security Alert March 3, 2010 // 0 Comments If you are getting a certificate security alert with the following error when you open Outlook 2007. “the name on the [...]
How to Configure Virtual Servers Failover for Citrix Netscaler? March 2, 2010 // 0 Comments Below are instructions on configuring Virtual Servers failover in a Netscaler device 1. Login to the Configuration page for [...]
How to enable Wake on LAN WOL February 4, 2010 // 0 Comments To enable Wake on LAN or for short WOL or PME, you will need to make sure that your hardware supports it. There are two [...]
How to connect a modem into the AUX or CON port? October 13, 2009 // 0 Comments Here are the steps in setting up a US Robotics Modem to work on a Cisco AUX or CON port. 1. Connect a RJ45 to DB25 adapter [...]
Can’t find server name for address x.x.x.x: Non-existent domain September 23, 2009 // 0 Comments If you ran into this error with your DNS server, then most likely you forgot to setup the PRT entry for the DNS server. [...]
Is NetFlow supported on Cisco Switches? September 17, 2009 // 1 Comment Unfortunately, Netflow is only supported on L2 devices (e.g. Routers). Switches such as Catalyst 2900, 3500, and 3700 [...]
How to add multiple dns entries with netsh? September 10, 2009 // 0 Comments If you want to add multiple dns entries using the netsh utility, you can do it by using the following commands. netsh [...]